Sterndrives.Com     Mercruiser Sterndrive Information
Mercruiser Parts Mercruiser Help Mercruiser Manuals Mercruiser Tools Mercruiser Sterndrives Contact
My Engine Turns Over OK But It Won't Start

If your engine won't crank or turn over, go HERE.

So you know your battery is good and the starter works OK because the engine turns when you try to start it. You crank and crank and crank but it just won't run.

There are many reasons why an engine won't start. It's usually something simple.

An engine needs spark, fuel and air and compression to run. The spark has to be strong enough and at the correct "time". The fuel has to be adequate and the engine has to have enough compression.

A good technician will first perform a general inspection of the motor and systems. A loose connection on the back of the key switch or even a bad keyswitch could prevent a motor from starting like it should.

A quick check of the carburetor will allow to confirm the engine is getting fuel. This is usually done by advancing the throttle lever while lloking down into the throat of the carb. You should see a spray of fuel as the throttle is being advanced. If the carb looks dry, it is! A closed fuel valve, a faulty antisyphon valve, a bad fuel line or a clogged fuel filter can prevent fuel from reaching the carburetor. We even have an occasional cutomer with no fuel in the tank!

A bad fuel pump can also prevent fuel from reaching the carb. Fuel injected engines are VERY fussy about fuel supply and fuel pressure. Many engines use an electric fuel pump and others use both an electric fuel pressure pump and a mechanical "lift" pump.

Electric fuel pumps can easily go bad from just sitting. The fuel turns into varnish and the pump fails. If you are going to let your boat sit for 6 months or more, you should run Fuel Stabilzer through the fuel system.
The Fuel Stabilzer will keep the fuel from ruining the fuel pump.

Electric fuel pumps make a whinning noise when they run. Most come on for about 5 seconds when the key is first turned on. If you have an electric fuel pump and you don't hear it making any noise when the key is on, you might have a bad fuel pump. You might also have a bad connection on your Oil Pressure Switch. There is an Oil Pressure Switch which keeps voltage to the electric fuel pump once the engine is running. If the oil pressure drops, the fuel pump stops and the engine shuts off as a protection feature. The switch is mounted down low on the port side of the engine block and it can get splashed with water. Unsnap the plastic harness plug from the oil pressure switch and make sure the connections are perfect.

If You Have Fuel

If you have fuel, you need to check for spark. Careful! Mercruisers have a powerful ignition system that will shock the hell out of you!

Your local Auto Parts Supply Store will usually sell a Spark Tester. Get the best spark tester they have. This is a great tool to keep in your boats tool box. Remove the main coil lead from the center of the distributor cap and install the Spark Tester. Make sure the other end of the tester is attached to a good clean ground. Crank the engine and check for spark. If you have no spark, there are several things which can be at fault.

Below is a quick list of items which can cause a "no spark" condition from the coil:

1. A bad key switch.
2. A blown ignition fuse.
3. A bad harness connection or bad harness.
4. A bad shift cable.
5. A faulty Shift Interuptor Switch on the shift plate assembly.
6. A shorted tachometer.
7. A removed or faulty Safety Lanyard Switch.
8. A bad ignition coil.
9. Breaker Points worn or not adjusted (conventional ignition).
10. A bad condensor (conventional ignition).
11. A faulty sensor (Thunderbolt or Delco).
12. A bad Ignition Module (actually very rare).
13. A bad timing chain (rotor does not turn).

In depth troubleshooting can be found in the Factory Service Manuals for your engine.

Safety
Boats can explode. Moving parts can rip off your fingers. Hot exhaust can burn you to the bone and props can slice you up. One spark near a battery can cause an explosion. You can never be too careful. Remove the battery from the boat before working with fuel. Always disconnect the batteries negative terminal first. Clean up any spilt fuel and let ALL of the fumes dissipate before installing the battery and starting the motor. Pulleys and Belts can grab your clothes and hair. Don't wear loose clothing and keep your hair up under a hat. Always wear safety glasses. Be smart.
Sterndrive-Information
Change your Alpha Gear Lube
Change your Bravo Gear Lube
Why does my drive lube have white streaks?
Why does my drive lube have gray mush?
Replace Your Alpha One Water Pump
Replace your Alpha Gen II Water Pump
Rebuild your Bravo Raw Water Pump

Troubleshoot & Replace your Alpha Shift Cable
Troubleshoot & Replace your Bravo Shift Cable

Replace your Alpha One Bellows & Gimbal Bearing
Replace your Alpha Gen II Bellows & Gimbal bearing
Replace your Bravo Bellows & Gimbal Bearing
Why does my drive "Growl" when I turn?
Water is leaking into my boat from the transom

Replacing your Trim Sender Switches
My Trim doesn't work but my Trailer Switch does
My Trim Gauge is Pegged

Rebuild your Alpha One Upper Driveshaft Housing Assembly
Rebuild your Alpha One Lower Gear Housing Assembly

Check your Engine Alignment
Check for Excessive Steering Play
Troubleshoot an Overheating Problem
Should I remove my thermostat?
Why do I overheat when going fast?
Troubleshoot a No-Crank Condition
Troubleshoot a No-Start Condition
My Engine Backfires and/or Surges and has Lack of Power
What is an Anti-Syphon Valve?
My Engine blows Steam from the Exhaust
Why do I hear a "clakity" sound while at idle?
Exhaust Manifolds...IMPORTANT Information
How do I Winterize my engine?

What is Galvanic Corrosion?
I have a Bravo III Galvanic Corrosion Problem
What is a Mercathode?
All about Zinc Anodes
How do I check my carburetor?
What carburetor do I have? A Rochester or a Mercarb?
I have water in my fuel
My fuel smells like varnish
My fuel is old
My engine has been sitting for several months without being run.

I have a Mercruiser 470, 485, 488, 190, 3.7L Engine
I have coolant dripping from the front of my engine
Can I install a regular Alternator instead of the Stator-Rotor?

Converting an OMC to a Mercruiser


©2004 Sterndrives.Com •EmailAbout UsHomeReturn Policy Mercruiser HelpShop ManualsSearchContact